TM 5-3805-248-14&P-1
To Shorten the Belt
To Lengthen the Belt
1.
1.
With the belt unfastened, move the
With the belt fastened, pull on the
anticreep slide toward the buckle.
outer loop to tighten the belt.
2. To remove the slack in the outer
2.
Move the anticreep slide toward the
loop, rotate the buckle to free the lock bar.
anchor end of the belt to take up the slack
This permits the belt to move through the
in the outer loop.
buckle.
3.
Pull on the buckle until the outer and
inner belt loops are tight.
3.
Adjust the other half of the belt in the
same manner.
4.
4. Readjust the belt if it does not fit
L oosen the other half of the belt in
the same manner. Readjust the belt if it
properly with the buckle in the center.
does not fit properly with the buckle in
the center.
9
