TM 5-3805-248-23-1
TORQUE CONVERTER OIL COOLER LINES REPLACEMENT - CONTINUED
0137 00
CLEANING AND INSPECTION
WARNING
Solvent, cleaning compound MIL-PRF-680 Type III is an environmentally compliant and low toxic
material. However, it may be irritating to the eyes and skin. Use protective gloves and goggles. Use in
well-ventilated areas. Keep away from open flames and other sources of ignition.
Particles blown by compressed air are hazardous. DO NOT exceed 15 psi (103 kPa) nozzle pressure
when drying parts with compressed air. Use a maximum of 30 psi (207 kPa) when cleaning compo-
nents. DO NOT direct compressed air against human skin. Failure to follow this warning may result in
injury or death. Make sure air stream is directed away from user and other personnel in the area. To pre-
vent injury, user must wear eye protection.
1.
Remove all gasket and seal material from mounting surfaces.
2.
Clean all metal parts with solvent and rubber parts with detergent.
3.
Dry all parts with compressed air.
4.
Inspect all parts for damage and replace as necessary.
INSTALLATION
NOTE
Lightly coat new preformed packings and seals with clean oil prior to installation.
1.
Install new seal (10) and elbow (9) on torque converter oil cooler.
2.
Install hose assembly (3) on elbow (9).
3
9,10
TORQUE CONVERTER
394-325
OIL COOLER
0137 00-4
