TM 5-3805-248-23-2
ACCESSORY DRIVE GROUP REPLACEMENT - CONTINUED
0271 00
REMOVAL - CONTINUED
4.
Remove four bolts (14), washers (13) and cover (12)
11
10
from drive gear (5).
3
5.
Remove plug (11) from drive bearing (3).
6.
Remove two studs (10) from drive bearing (3).
5
12
13
14
394-1095
CLEANING AND INSPECTION
WARNING
Solvent cleaning compound MIL-PRF-680 Type III is an environmentally compliant and low toxic
material. However, it may be irritating to the eyes and skin. The use of protective gloves and goggles.
Use in well-ventilated areas. Keep away from open flames and other sources of ignition.
Particles blown by compressed air are hazardous. DO NOT exceed 15 psi (103 kPa) nozzle pressure
when drying parts with compressed air. Use a maximum of 30 psi (207 kPa) when cleaning compo-
nents. DO NOT direct compressed air against human skin. Failure to follow this warning may result in
injury or death. Make sure air stream is directed away from user and other personnel in the area. To pre-
vent injury, user must wear protective goggles or face shield.
1.
Remove all gasket material from mounting surfaces.
2.
Clean all parts with solvent and ensure that they are free of seal material, dirt and oil.
3.
Visually inspect parts for cracks, heat deterioration or other damage. Replace damaged parts as necessary.
4.
Dry parts with compressed air.
INSTALLATION
1.
Install two studs (10) and plug (11) to front left side of engine.
2.
Install cover (12), four washers (13) and bolts (14) to drive gear (5).
0271 00-2
