TM 5-3805-248-23-2
CONTROL GROUP PRESSURE TEST - CONTINUED
0284 00
TESTING - CONTINUED
NOTE
The following oil pressures are initialed. Refer to Table 2, Initial Pressure Chart, in this work package.
69.
Shut down engine (TM 5-3805-248-10).
70.
Install transmission hydraulic test set.
71.
Connect 0-200 psi pressure gage to tap A.
72.
Use locking pliers to shift manual selector shaft into REVERSE.
E (HIDDEN)
B
A
F
C
394-823
73.
Rotate hand lever to increase engine speed on transmission hydraulic test set tachometer to 750 RPM, and record pres-
sure reading on pressure gage for tap A.
74.
Remove bolt G.
75.
Connect 0-150 psi pressure gage to pressure tap C.
76.
Use locking pliers to shift manual selector into NEUTRAL, and record pressure reading on pressure gage for tap C.
77.
Install bolt G.
78.
Remove bolt H.
79.
Connect 0-600 psi pressure gage to pressure tap B and record pressure reading on pressure gage for tap B.
80.
Rotate hand lever to increase engine speed on transmission hydraulic test set tachometer to 2,250 RPM, and record pres-
sure reading on pressure gage for tap B.
0284 00-13
