TM 5-3805-248-23-2
APRON LIFT MECHANISM MAINTENANCE - CONTINUED
0387 00
DISASSEMBLY
1.
Use a brass driver and hammer to remove two bushings (14), one from each end of link (2).
2.
Use a brass driver and hammer to remove two bearings (15) and spacer (16) from larger end of frame (1).
1
2
14
15
394-1471
15 16
CLEANING AND INSPECTION
WARNING
Solvent cleaning compound MIL-PRF-680 Type III is an environmentally compliant and low toxic
material. However, it may be irritating to the eyes and skin. Use protective gloves and goggles. Use in
well-ventilated areas. Keep away from open flames and other sources of ignition.
Particles blown by compressed air are hazardous. DO NOT exceed 15 psi (103 kPa) nozzle pressure
when drying parts with compressed air. Use a maximum of 30 psi (207 kPa) when cleaning compo-
nents. DO NOT direct compressed air against human skin. Failure to follow this warning may cause
injury or death. Make sure air stream is directed away from user and other personnel in the area. To pre-
vent injury, user must wear protective goggles or face shield.
1.
Clean trunnion mounts on bowl with solvent cleaning compound.
2.
Dry all parts with compressed air.
3.
Inspect all parts for damage and replace as necessary.
ASSEMBLY
1.
Use a brass driver and hammer to install spacer (16) and two bearings (15) in the larger end of frame (1).
2.
Use a brass driver and hammer to install two bushings (14), one in each end of link (2).
0387 00-5
