TM 5-3805-260-24
CYLINDER HEADS
4. Install water sleeves into cylinder heads tool (A). Install
the clamps on the water sleeves.
5. Put the fuel line junction block in position and install nut
(3) to hold it.
6. Install fuel lines (I) and (2) on the engine.
7. Put alternator bracket (4) in position and install the three
bolts and washers to hold it.
8. Install bolt (6) and the washer to hold the guide for the oil
level gauge.
9 . Put the gasket and plate (5) for the air compressor in
position on the timing gear cover and install the four
bolts and washers to hold it.
10. Fill the cooling system with coolant to the correct
level.
end by:
a) install fuel injection nozzles
b) install rocker shafts and push rods
c) install fuel injection lines and air inlet manifold
d) install exhaust manifold
e) install belt tightener (water pump)
f) install air cleaner housing and panel assembly
g) install air compressor install alternator
3-105
