TM 5-3800-205-23-1
DIFFERENTIAL AND BEVEL GEAR REPLACEMENT - CONTINUED
0152 00
INSTALLATION
1.
Coat new O-ring with oil and install.
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during proc-
dure. Ensure that any lifting device used is in good condition and of suitable lift capacity. Keep clear of
heavy suitable lift capacity. Keep clear of heavy parts supported only by lifting device. Failure to follow this
warning may result in death or injury to personnel.
NOTE
Differential weighs 450 lb (204 kg).
2.
Install differential on axle housing (1) with ten bolts
13,14
16,17
11
12
(13), washers (14), two top bolts (16), and washers
(17). Tighten bolts to 200 lb-ft (270 Nm). Remove
floor jack from differential.
3.
Slowly and carefully raise axle housing (1), using
guide pins (10) to assist in aligning axle housing. Con-
nect hose (11) to differential and tighten retaining nut
(12).
4.
Loosely install four outer nuts (8) on axle housing (1).
5.
Remove four guide pins (10) and inner four inner bolts
10
(9).
1
6.
Install four inner nuts (8) on axle housing (1). Tighten
1
all eight nuts.
9
8
0152 00-5