MWO 5-2350-262-35-1
e. Additional information deemed necessary to assist in the application of this MWO:
PUBLICATIONS:
AR 750-10
TM 750-245-4
DA Pam 738-751
MIL-PRF-63002H(TM)
DA Pam 738-750
TB 43-0209
1-7
TECHNICAL PUBLICATIONS AFFECTED/CHANGED
PUBLICATIONS:
TM 5-2350-262-20-1, dated January 1997, with Change 3, dated March 2000
TM 5-2350-262-20-2, dated January 1997, with Change 3, dated March 2000
TM 5-2350-262-24P, dated March 2000
TM 5-2350-262-34, dated January 1997, with Change 2, dated March 2000
1-8
MWO KITS/PARTS AND THEIR DISPOSITION
a. See applicable chapter for parts.
b. Return removed (no longer required) parts to Unit for disposition.
1-9
SPECIAL TOOLS; TOOL KITS; JIGS; TEST, MEASUREMENT, AND DIAGNOSTIC
EQUIPMENT (TMDE); AND FIXTURES REQUIRED
See applicable chapter for tools/kits.
1-10
MODIFICATION PROCEDURES
See applicable chapter for modification procedures.
1-11
CALIBRATION REQUIREMENTS
Not applicable.
1-12 WEIGHT AND BALANCE DATA
Weight and balance are not significantly affected.
1-13 QUALITY ASSURANCE REQUIREMENTS
a. General. Quality assurance will be accomplished in accordance with TM 750-245-4.
b. Physical Inspection. Check components that are removed or installed during the modification for stability
of mounting.
c.
Functional Inspection. Start vehicle and insure that vehicle is operating properly, in accordance with TM
5-2350-262-10.
1-14 RECORDING AND REPORTING OF THE MODIFICATION
a. Records and Reports. The organization responsible for MWO application will report application
information as follows:
1-2
