MWO 5-2350-262-35-1
Table 2-2. Hardware Installation Guide - Continued
Figure/Table
Part Number
NSN
Description
Remarks
2266-8-8S
Adapter
H3-62-T8
QD, Coupler
Bottom of main
hydraulic
H3-63-T8
QD, Nipple
accumulator
202702-8-8S
Adapter
2266-10-10S
Adapter
H4-62-T10
QD, Coupler
Ejector
H4-63-T10
QD, Nipple
cylinder
202702-10-10S
Adapter
2266-8-8S
Adapter
H3-62-T8
QD, Coupler
Ejector
H3-63-T8
QD, Nipple
cylinder
202702-8-8S
Adapter
SECTION IV. MODIFICATION PROCEDURES
NOTE
Pay attention to all Notes, Cautions, and Warnings per TM 5-2350-262-34, Power Package
Replacement.
This procedure requires the power package to be completely disconnected from the vehicle
and removed by following the steps below.
WARNING
High pressure is present in the M9 hydraulic system. Do not disconnect any
hydraulic system component unless hydraulic system pressure has been
relieved. Failure to comply may result in severe injury or death.
a.
Perform INITIAL SETUP for power package removal and installation procedures per TM 5-2350-262-34,
Power Package Replacement.
WARNING
Air system contains high pressure. Do not disconnect any air system hose,
tube, or fitting unless air pressure has been relieved. Failure to comply may
result in severe injury to personnel.
NOTE
Step b below applies to Figure 2-1.
b.
Remove and reinstall quick-disconnect (2) on air compressor line with male coupling to air compressor
(1). Verify quick-disconnect (3) on fuel return line has male coupling to fuel tank.
