Figure 2-3. Compensating Pump between Hose and Elbow

MWO 5-2350-262-35-1

NOTE

Steps (1) through (4) below apply to Figure 2-3.

(1)

While performing TASK F per TM 5-2350-262-34, Power Package ReplacementInstallation,

adjust 90 elbow (2) on compensating pump to face up and angle towards transfer case.

Figure 2-3. Compensating Pump between Hose and Elbow

(2)

Install quick-disconnect (3) on compensating pump at elbow (2) with male coupling to

compensating pump.

(3)

Install new 90 elbow (4) to female half quick-disconnect coupling (3).

(4)

Reroute hose (5) up through front tubes on manifold, next to compensating pump, and above

compensating pump to 90 elbow (4).

NOTE

Steps (5) (a), (b), and (c) below apply to Figure 2-4.

(5)

While performing TASK J and K per TM 5-2350-262-34, Power Package Replacement

Installation, perform the following steps:

(a) Remove and discard cap screw (9), retaining strap (8), flat washer (6), and nut (5) from

bracket (1).

(b) Remove and discard two cap screws (7), flat washers (4), nuts (3), and bracket (1) from plate

(2).

(12) from hull bottom plate.

2-7