TM 5-3800-205-10-1
AIR TRANSPORT BY C-130 AIRCRAFT - CONTINUED
0018 00
CONFIGURE MACHINE FOR AIR TRANSPORT - CONTINUED
NOTE
Whenever hydraulic hose quick disconnects need to be disconnected, operate control levers through all posi-
tions (WP 0004 00) to relieve any trapped hydraulic pressure in hoses. This will facilitate disconnection of
hoses.
2.
Position machine on level ground, in staging area off tarmac. Ensure tractor and scraper are aligned and steering wheel
is centered.
3.
Move ejector fully to the rear and close floor of bowl. Place transmission in N (Neutral) and lock, apply parking brake,
and lower bowl to the ground. Shut down engine. Block tractor and scraper wheels.
4.
Remove two nuts and windshield wiper arm assembly from windshield. Set wiper arm assembly aside for stowage in
ISU-60 container. Reinstall nuts on drive and pivot shafts.
PIVOT AND
WINDSHIELD WIPER
DRIVE SHAFT NUTS
ARM ASSEMBLY
390-1060
WINDSHIELD
0018 00-5
