TM 5-3800-205-10-1
AIR TRANSPORT BY C-130 AIRCRAFT - CONTINUED
0018 00
CONFIGURE MACHINE FOR AIR TRANSPORT - CONTINUED
WARNING
Configuration change at cutting edge should NEVER be attempted without first securing the bowl by block-
ing it so that it is firmly supported. Failure to follow this warning may cause injury to personnel.
11.
Attach two scraper bowl cutting edge wheels:
a.
Raise bowl approximately 10 in. (25.4 cm) from the ground. Block bowl securely.
b.
With assistance and using a pry bar, position each cutting edge wheel centered on gusset underneath cutting edge,
with locks engaged over top rear edge of cutting edge.
c.
Fully and evenly tighten two setscrews to secure each cutting edge wheel.
TOP REAR
2ND GUSSET
EDGE OF
HOOKS
IN FROM EDGE
CUTTING EDGE
390-1968
SETSCREWS
CUTTING
EDGE WHEEL
CAUTION
Do NOT power down scraper bowl. If powered down, cylinder force could overload cutting edge wheels,
causing them to become damaged.
12.
Raise cutting edge off blocks, remove blocks, then shut down engine. With engine off, lower scraper bowl until weight
rests on cutting edge wheels.
0018 00-20
