TM 5-3800-205-10-1
AIRDROP BY C-130 AIRCRAFT - CONTINUED
0019 00
CONFIGURE MACHINE FOR AIRDROP
NOTE
Whenever hydraulic hose quick disconnects need to be disconnected, operate control levers through all posi-
tions (WP 0004 00) to relieve any trapped hydraulic pressure in hoses. This will facilitate disconnection of
hoses.
1.
Position machine on level ground. Ensure tractor and scraper are aligned and steering wheel is centered. Move ejector
fully to the rear and close floor of bowl. Place transmission in N (Neutral) and lock, apply parking brake, and lower
bowl to the ground. Shut down engine. Block tractor and scraper wheels.
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during proce-
dure. Ensure that any lifting device used is in good condition and of suitable lift capacity. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may result in death or injury to
personnel.
2.
Place ISU-60 container near work area and remove the following items from container:
a.
toolbox;
b.
exhaust extension;
c.
four steering locking collar assemblies, two short (6 5/8 in.) and two long (10 3/4 in.);
NOTE
Before removing ladder, unscrew retainer and remove post.
d.
ladder; and
e.
pry bar.
CENTER POST
STEERING CYLINDER
PRY BAR
RETAINER
LADDER
EXTENSION
LOCKING COLLAR ASSEMBLIES
390-1119
390-1118
TOOLBOX
CONTAINER CENTER POST
0019 00-3
