TM 5-3800-205-23-1
TESTS, INSPECTIONS, AND ADJUSTMENTS
INTRODUCTION
1.
This work package includes miscellaneous tasks, inspections, and adjustment procedures that are performed in conjunc-
tion with troubleshooting or as a function of maintenance.
2.
The following is a list of procedures covered in this work package:
a.
Troubleshooting Using Multimeter
b.
Differential Lock Check
c.
Electronic Monitoring System (EMS) Air System Check
d.
Air System Pressure Check
e.
Air Compressor Governor Adjustment
f.
Air Leakage Checks
g.
Parking and Emergency Brake Control Valves Test
h.
Steering System Pressure Test
i.
Steering Time Check
j.
Steering Wheel Force Check
k.
Steering Wheel Free Play Check
l.
Steering Wheel Slip Check
m.
Main Control Valve Test and Adjustment
n.
Elevator Operating Speed Check
WARNING
If machine is parked indoors, DO NOT run engine unless exhaust fumes are vented to the outside. Failure to
follow this warning may cause injury or death due to carbon monoxide poisoning.
3.
If machine is parked indoors during performance of troubleshooting, vent exhaust fumes to the outside if engine is run-
ning.
TROUBLESHOOTING USING MULTIMETER
1.
Introduction.
a.
This section applies to troubleshooting machine's starting and charging circuits using a multimeter. It can be
applied to a machine that can self-start, and to a machine that cannot self-start. When using these procedures for a
machine that cannot self-start, refer to TM 5-3800-205-10-1 or TM 5-3800-205-10-2 for slave starting procedures.
