TM 5-3800-205-23-1
ENGINE AND TRANSMISSION SPEED SENSORS REPLACEMENT
0062 00
ENGINE SPEED SENSOR REPLACEMENT - CONTINUED
4.
Transfer position mark from old sensor (3) to new sensor.
5.
Install sensor (3) until position mark on sensor is even with top of flywheel housing (5).
6.
Tighten locknut (4) on sensor (3) while holding sensor flat.
7.
Connect sensor connector (1) to harness connector (2) and secure connectors in clip.
8.
Close engine access door (TM 5-3800-205-10-1 or TM 5-3800-205-10-2).
2
1
3
4
5
TRANSMISSION SPEED SENSOR REPLACEMENT
1.
Disconnect sensor connector (10) from harness connector (6).
2.
Hold sensor (8) and loosen locknut (7).
NOTE
Mark bottom of sensor to aid in installation.
3.
Remove sensor (8) from housing (9).
4.
Transfer position mark from old sensor (8) to new sensor.
5.
Install sensor (8) until position mark on sensor is even with top of housing (9).
6.
Tighten locknut (7) on sensor (8) while holding sensor flat.
7.
Connect sensor connector (10) to harness connector (6).
0062 00-2