TM 5-3800-205-23-1
TRANSMISSION SHIFT CONTROL CABLE REPLACEMENT - CONTINUED
0069 00
REMOVAL - CONTINUED
2.
Remove two screws (4), washers (5), and work light bracket (3), with work light (1), from cover (6).
NOTE
Three cable clamps, washers, and one cable connector holder are also removed as transmission cover is
removed. Note position of clamps, washers, and cable connector holder to aid in installation.
3.
Remove 10 screws (9), four washers (10), cover (6),
and gasket (7) from linkage housing (8). Discard gas-
ket.
3
4,5
9,10
8
6,7
4.
Remove screw (21), washer (22), and bearing (18) from cam (20).
NOTE
Note position of bearing and nut on shift control cable to aid in installation.
5.
Remove grease fitting (19), bearing (18), and nut (17) from shift control cable (16).
NOTE
Note position of two nuts, washers, and seal washer on shift control cable to aid in installation.
6.
Remove nut (11), washer (12), and seal washer (13) from shift control cable (16). Discard seal washer.
7.
Pull shift control cable (16) out through hole in linkage housing (8).
0069 00-2