TM 5-3805-248-10
ADVANCED OPERATION AND OPERATOR TIPS
SCOPE
NOTE
The information in this work package is provided as a supplement to the basic operating procedures
described in WP 0005 00. A thorough reading and understanding of both this work package and WP 0005 00
is essential to safe and efficient machine operation.
1.
This work package is designed to provide general information as well as advanced operating tips to maximize machine
efficiency and potential.
2.
Proper job site management, which is also crucial to work efficiency, is addressed in WP 0007 00.
MACHINE SERVICES AND ADJUSTMENTS
1.
Machine Services.
a.
To ensure safe and efficient operation, the operator is responsible for performing PMCS at the job site. This will
ensure the machine is ready to perform its mission and will reduce downtime due to machine failures.
b.
To facilitate performance of PMCS, ensure machine is clean. Wash machine to remove dust and dirt that could inter-
fere with inspections and preventive maintenance.
c.
After operation, determine requirements of next mission, so that machine adjustments can be made in advance, if
required.
NOTE
Unit Maintenance must perform configuration changes to cutting edge.
2.
Blocking Bowl.
a.
Park machine on level ground.
b.
Engage parking brake and block wheels.
c.
Raise bowl. Place a block of wood centered under bowl. Ensure wood is of sufficient strength to carry weight of
bowl, and large enough so that bowl will be supported at a suitable height.
d.
Lower bowl until weight of bowl is fully resting on block of wood.
e.
Move bowl control lever to middle HOLD position.
f.
Place transmission control lever in N (Neutral) position. Engage transmission neutral lock.
g.
Shut down engine.
