TM 5-3805-248-10
ENGINE AIR PRECLEANER AND AIR CLEANER ASSEMBLY SERVICING - CONTINUED
0015 00
ENGINE AIR CLEANER ASSEMBLY SERVICING - CONTINUED
NOTE
A primary element may be cleaned a maximum of six times. Also, replace primary element if it has been in
service for one year.
7.
If primary element is OK, clean as follows:
WARNING
Compressed air used for cleaning purposes should never exceed 30 psi (207 kPa). Pressurized water used for
cleaning purposes should not exceed 40 psi (276 kPa). To prevent injury, user must wear protective goggles
or face shield.
NOTE
Do NOT clean primary element by tapping or bumping element.
a.
Use compressed air or pressurized water to clean inside and outside pleats by directing stream along pleats. A solu-
tion of detergent and water may be used as required.
b.
Fully rinse pleats.
c.
Allow primary element to air dry completely.
8.
Inspect primary element again. If pleats or seals are damaged, discard primary element and obtain a replacement.
NOTE
Primary element must be completely dry before installation.
9.
Install primary element inside air cleaner housing.
PRIMARY
ELEMENT
HOUSING
394-011
0015 00-4