TM 5-3805-248-23-1
STEERING COLUMN AND SHAFT REPLACEMENT - CONTINUED
0178 00
DISASSEMBLY
1.
Remove nut (13) assembly from steering column assembly (5).
2.
Remove fitting (19) and seal (20) from nut (13). Discard seal.
3.
Remove plug (18) and grommet (17) from steering column assembly (5).
4.
Remove shaft (16) assembly from steering column assembly (5).
5.
Remove retaining ring (14).
6.
Remove bearing (15) from shaft (16).
20
13
14
15
5
16
19
18
17
394-456
CLEANING AND INSPECTION
WARNING
Solvent cleaning compound MIL-PRF-680 Type III is an environmentally compliant and low toxic
material. However, it may be irritating to the eyes and skin. Use protective gloves and goggles. Use in
well-ventilated areas. Keep away from open flames and other sources of ignition.
Particles blown by compressed air are hazardous. DO NOT exceed 15 psi (103 kPa) nozzle pressure
when drying parts with compressed air. Use a maximum of 30 psi (207 kPa) when cleaning compo-
nents. DO NOT direct compressed air against human skin. Failure to follow this warning may result in
injury or death. Make sure air stream is directed away from user and other personnel in the area. To pre-
vent injury, user must wear protective goggles or face shield.
1.
Remove all gasket material from mounting surfaces.
2.
Clean all parts with solvent.
3.
Dry parts with compressed air.
4.
Inspect parts for damage. Replace damaged parts as necessary.
0178 00-3
