TM 5-3805-248-23-1
CUTTING EDGES REPLACEMENT - CONTINUED
0252 00
REMOVAL
1.
Raise bowl high enough to position wood blocks under bowl.
2.
Position wood blocks at sides of bowl, 15 in. (38 cm) behind cutting edges and lower bowl onto wood blocks.
3.
WARNING
Use caution when handling heavy parts. Provide adequate support and use assistance during procedure.
Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of heavy
parts supported only by lifting device. Failure to follow this warning may cause injury or death.
NOTE
Weight of center cutting edge is 175 lb (79 kg). Weight of side cutting edges is 85 lb (39 kg) each. Router
bits weigh 48 lb.
4.
Position floor jack under center cutting edge (4).
5.
Remove nine nuts (5) and bolts (6) from center cutting edge of bowl.
6.
Use floor jack to remove center cutting edge (4).
7.
Remove ten nuts (1) and bolts (2) from left and right side cutting edges (3).
8.
Use assistance to remove right and left side cutting edges (3).
9.
Remove ten nuts (7) and bolts (8) from right and left router bits (9).
10.
Remove right and left router bits (9).
5,6
4
3
1,2
7,8
9
394-585
0252 00-2