TM 5-3805-248-23-2
PUSH RODS AND ARMS REPLACEMENT - CONTINUED
0265 00
CLEANING AND INSPECTION
WARNING
Solvent cleaning compound MIL-PRF-680 Type III is an environmentally compliant and low toxic
material. However, it may be irritating to the eyes and skin. Use protective gloves and goggles. Use in
well-ventilated areas. Keep away from open flames and other sources of ignition.
Particles blown by compressed air are hazardous. DO NOT exceed 15 psi (103 kPa) nozzle pressure
when drying parts with compressed air. Use a maximum of 30 psi (207 kPa) when cleaning compo-
nents. DO NOT direct compressed air against human skin. Failure to follow this warning may result in
serious injury or death. Make sure air stream is directed away from user and other personnel in the area.
To prevent injury, user must wear protective goggles or face shield.
1.
Clean all parts with solvent.
2.
Dry all parts with compressed air.
3.
Inspect all parts for damage and replace as necessary.
INSTALLATION
NOTE
Use numbers made during removal to install all push rods in original position.
1.
Install six push rods (4).
3
1
2.
Position rocker shaft assembly (1) on cylinder head.
2
1
3.
Use lubricating oil to lubricate three washers (2) and
threads of bolts (3).
4.
Install three washers (2) and bolts (3) on rocker shaft
assembly (1). Starting with center bolt, torque all three
4
bolts (3) to 200 lb-ft (271 Nm). Torque all three bolts
(3) again to 330 lb-ft (447 Nm).
CYLINDER
HEAD
394-644
0265 00-2
