TM 5-3805-248-23-2
GOVERNOR CONTROL MAINTENANCE - CONTINUED
0280 00
ADJUSTMENT
NOTE
The following procedure is for the adjustment of the spring link. This procedure does not affect high or low
idle speeds. Use an assistant to press pedal while checking governor shaft.
1.
Press pedal (34).
18
3
2.
Check governor shaft. Spring link (6) is adjusted cor-
rectly if governor shaft is against stop.
3.
Loosen nut (18).
4.
Remove nut (2), washer (3) and bolt (5).
2
5.
Rotate spring link (6) clockwise to shorten spring link;
counterclockwise to lengthen spring link.
34
6
6.
Install bolt (5), washer (3) and nut (2).
7.
Tighten nut (18).
394-719
GOVERNOR
5
SHAFT
8.
Operate engine and verify correct operation of governor (TM 5-3805-248-10).
9.
Install hood (WP 0189 00).
END OF WORK PACKAGE
0280 00-12
