TM 5-3805-248-23-2
TRANSMISSION REPLACEMENT - CONTINUED
0286 00
CLEANING AND INSPECTION - CONTINUED
1.
Remove all gasket material from mounting surfaces.
2.
Clean all parts with solvent cleaning compound.
3.
Dry all parts with compressed air.
4.
Inspect all parts for damage and replace as necessary.
INSTALLATION
1.
Remove all gasket material from mounting surfaces.
2.
Attach differential assembly to transmission assembly (WP 0295 00).
3.
Install 3/4-10NC link bracket into top of transfer case.
WARNING
Use caution when handling heavy parts. Provide adequate support and use assistance during procedure.
Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of heavy
parts supported only by lifting device. Failure to follow this warning may cause injury or death.
NOTE
Weight of retarder transmission is 4,500 lb (2,041 kg).
Place hydraulic floor jack under retarder oil cooler assembly for support.
4.
Attach lifting device to link bracket and to front lifting eye.
5.
Install transmission and differential on mounting studs.
6.
Install four washers (34) and nuts (35) on studs opposite each other.
7.
Tighten the four nuts (35) until transmission is flush against the differential case.
8.
Install 16 washers (34) and nuts (35).
9.
Remove link bracket and lifting device.
0286 00-7
