TM 5-3805-248-23-2
FLYWHEEL SCAVENGE RETARDER PUMP MAINTENANCE - CONTINUED
0288 00
DISASSEMBLY - CONTINUED
44
4.
Remove and discard seal (46) from cover (44).
5.
Use brass driver and hammer to remove two sleeve
45
46
bearings (45) from cover (44).
394-762
6.
Remove gears (38 and 43).
38
7.
Use brass driver and hammer to remove two sleeve
bearings (39) and seal (41) from manifold (40). Dis-
39
40
card seal.
8.
Use dowel puller to remove two dowels (42).
41
43
39
42
394-761
CLEANING AND INSPECTION
WARNING
Solvent cleaning compound MIL-PRF-680 Type III is an environmentally compliant and low toxic
material. However, it may be irritating to the eyes and skin. Use protective gloves and goggles. Use in
well-ventilated areas. Keep away from open flames and other sources of ignition.
Particles blown by compressed air are hazardous. DO NOT exceed 15 psi (103 kPa) nozzle pressure
when drying parts with compressed air. Use a maximum of 30 psi (207 kPa) when cleaning compo-
nents. DO NOT direct compressed air against human skin. Failure to follow this warning may result in
injury or death. Make sure air stream is directed away from user and other personnel in the area. To pre-
vent injury, user must wear eye protection.
1.
Remove all gasket material from mounting surfaces.
2.
Clean all parts with solvent.
3.
Dry all parts with compressed air.
4.
Inspect all parts for damage and replace as necessary.
0288 00-5
