TM 5-3805-248-23-2
REAR AXLE HOUSING REPLACEMENT - CONTINUED
0298 00
CLEANING AND INSPECTION
WARNING
Solvent cleaning compound MIL-PRF-680 Type III is an environmentally compliant and low toxic
material. However, it may be irritating to the eyes and skin. Use protective gloves and goggles. Use in
well-ventilated areas. Keep away from open flames and other sources of ignition.
Particles blown by compressed air are hazardous. DO NOT exceed 15 psi (103 kPa) nozzle pressure
when drying parts with compressed air. Use a maximum of 30 psi (207 kPa) when cleaning compo-
nents. DO NOT direct compressed air against human skin. Failure to follow this warning may result in
injury or death. Make sure air stream is directed away from user and other personnel in the area. To pre-
vent injury, user must wear eye protection.
1.
Remove all gasket material from mounting surfaces.
2.
Clean all parts with solvent.
3.
Dry all parts with compressed air.
4.
Inspect all parts for damage and replace as necessary.
INSTALLATION
1.
Apply anti-seize compound to coat 22 washers (3) and bolts (2).
2.
Attach lifting device to axle housing (1).
WARNING
Use caution when handling heavy parts. Provide adequate support and use assistance during procedure.
Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of heavy
parts supported only by lifting device. Failure to follow this warning may result in injury or death.
NOTE
Weight of axle housing is 340 lb (154 kg).
3.
With assistance, use lifting device, position axle housing (1) against machine.
4.
Install 22 washers (3) and bolts (2). Torque 22 bolts (2) to 200 lb-ft (271 Nm).
5.
Install tire and wheel (WP 0303 00).
6.
Install brake adjusters and camshafts (WP 0147 00).
7.
Install brake shoes (WP 0150 00).
8.
Operate machine and verify correct operation (TM 5-3805-248-10).
END OF WORK PACKAGE
0298 00-3/-4 Blank
