TM 5-3805-248-23-2
ENGINE FRONT COVER PLATE REPLACEMENT - CONTINUED
0341 00
CLEANING AND INSPECTION
WARNING
Solvent cleaning compound MIL-PRF-680 Type III is an environmentally compliant and low toxic
material. However, it may be irritating to the eyes and skin. Use protective gloves and goggles. Use in
well-ventilated areas. Keep away from open flames and other sources of ignition.
Particles blown by compressed air are hazardous. DO NOT exceed 15 psi (103 kPa) nozzle pressure
when drying parts with compressed air. Use a maximum of 30 psi (207 kPa) when cleaning compo-
nents. DO NOT direct compressed air against human skin. Failure to follow this warning may result in
injury or death. Make sure air stream is directed away from user and other personnel in the area. To pre-
vent injury, user must wear protective goggles or face shield.
1.
Remove all gasket material from mounting surfaces.
2.
Clean all parts with solvent and ensure that they are free of seal material, dirt and oil.
3.
Dry parts with compressed air.
4.
Visually inspect parts for cracks, heat deterioration or other damage. Replace damaged parts as necessary.
INSTALLATION
1.
Apply sealing compound to both faces of new gasket (6) and position new gasket and plate (5) on front of engine (7).
2.
Install seven washers (4) and bolts (3) in front of engine (7).
3.
Apply sealing compound to both faces of new gasket (2) and ribbed part of stud (1).
4.
Install washer (2) and stud (1).
5.
Cut excess of new gasket (6) flush with bottom of plate (5).
6.
Install accessory drive group (WP 0271 00).
7.
Install automatic timing advance (WP 0278 00).
8.
Install idler gear (WP 0352 00).
9.
Operate machine and verify correct operation (TM 5-3805-248-10).
END OF WORK PACKAGE
0341 00-3-4 Blank
