TM 5-3805-248-23-2
RADIATOR REPAIR - CONTINUED
0357 00
CLEANING AND INSPECTION
WARNING
Solvent cleaning compound MIL-PRF-680 Type III is an environmentally compliant and low toxic
material. However, it may be irritating to the eyes and skin. Use protective gloves and goggles. Use in
well-ventilated areas. Keep away from open flames and other sources of ignition.
Particles blown by compressed air are hazardous. DO NOT exceed 15 psi (103 kPa) nozzle pressure
when drying parts with compressed air. Use a maximum of 30 psi (207 kPa) when cleaning compo-
nents. DO NOT direct compressed air against human skin. Failure to follow this warning may result in
serious injury or death. Make sure air stream is directed away from user and other personnel in the area.
To prevent injury, user must wear eye protection.
1.
Remove all gasket and seal material from mounting surfaces.
2.
Clean all parts with solvent.
3.
Dry all parts with compressed air.
4.
Inspect all parts for damage and replace as necessary.
ASSEMBLY
1.
Apply adhesive to seal mounting surfaces of two damper assemblies (25) and install on core assembly (27).
2.
Install two new seals (24) on two damper assemblies (25).
3.
Install new gasket (29) and tank assembly (30) on core assembly (27).
4.
Position strips (28 and 31).
5.
Install 22 washers (35) and capscrews (26) hand tight.
6.
Position two brackets (36) and strips (32).
7.
Install ten washers (34) and capscrews (33) and hand-tighten.
8.
Install 12 washers (37) and capscrews (38) and hand-tighten.
9.
Tighten 22 capscrews (26), 12 capscrews (38) and ten capscrews (33) in sequence.
0357 00-5
