TM 5-3805-248-23-2
TRANSMISSION PLANETARY REPAIR - CONTINUED
0373 00
ASSEMBLY - CONTINUED
NOTE
There are four shaft assemblies of this type in carrier. The following assembly procedure is for one shaft
assembly. The assembly procedure for the remaining three shaft assemblies is identical.
52.
Install thrust washer (133) in carrier (115).
53.
Immerse bearings (136) and (135) in clean engine oil and install.
54.
Install thrust washer (137), gear (134) and tube (138).
55.
Install shaft (139).
132
133
CAUTION
134
135
Pins that hold shafts to carriers must be
136
installed flush with outer surface of carrier.
137
If they are installed further, they will pre-
138
vent oil flow for lubrication of the gears.
56.
If removed, install new spring pin (132) in carrier
(115).
115
139
394-1303
NOTE
There are two shaft assemblies of this type in carrier. The following is an assembly procedure for one shaft
assembly. The assembly procedure for the remaining shaft assembly is identical.
57.
Install thrust washer (120) in carrier (115).
58.
Immerse bearings (123) and (122) in clean engine oil and install.
59.
Install thrust washer (124), gear (121) and thrust washer (126) in carrier (115).
60.
Immerse bearings (129) and (128) in clean engine oil
115
and install.
120
61.
Install thrust washer (130), gear (127) and shaft (131)
in carrier (115).
CAUTION
121
Pins that hold shafts to carriers must be
122
installed flush with outer surface of carrier.
123 124
If they are installed further, they will pre-
125
vent oil flow for lubrication of the gears.
126
127
62.
If removed, install new spring pin (125).
128
129
130
131
394-1302
0373 00-39
