TM 5-3805-248-23-2
TRANSMISSION PLANETARY REPAIR - CONTINUED
0373 00
ASSEMBLY - CONTINUED
NOTE
There are three shaft assemblies in carrier. The following assembly procedure is for one shaft assembly. The
assembly procedure for the remaining two shaft assemblies is identical.
33.
Install thrust washer (169) on carrier (164).
34.
Immerse bearing (167) in clean engine oil.
35.
Install bearing (167), thrust washer (166), gear (168) and shaft (165).
CAUTION
165
Pins that hold shafts to carriers must be
166
installed flush with outer surface of carrier.
167
If they are installed further, they will pre-
vent oil flow for lubrication of the gears.
168
36.
Use pin punch and hammer to install new spring pin
(163), if removed, in carrier assembly (164).
169
164
163
394-1311
37.
Install carrier assembly (162) in planetary gear assembly.
38.
Install eight washers (161) and bolts (160).
160
161
162
PLANETARY
ASSEMBLY
394-1310
0373 00-35
