TM 5-3805-248-23-2
TRANSMISSION PLANETARY REPAIR - CONTINUED
0373 00
ASSEMBLY - CONTINUED
NOTE
There are three shaft assemblies of this type in carrier. The following assembly procedure is for one shaft
assembly. The assembly procedure for the remaining two shaft assemblies is identical.
114. Install thrust washer (51).
115. Immerse bearing (49) in clean engine oil.
116. Install gear (50), bearing (49), thrust washer (48) and
shaft (46).
35
CAUTION
46
47
Pins that hold shafts to carriers must be
installed flush with outer surface of carrier.
48 49
If they are installed further, they will pre-
50
vent oil flow for lubrication of the gears.
51
117. Use pin punch and hammer to install new spring pin
(47), if removed, in housing (35).
394-1279
118. Immerse bearing (44) in clean engine oil.
119. Note position of notch in bearing (44). Install bearing
43
(44) and ring (43).
120. Install three new preformed packings (45) in cage (42)
44
and turn cage (42) over.
45
45
42
394-1278
0373 00-51
