TM 5-3805-248-23-2
TRANSMISSION PLANETARY REPAIR - CONTINUED
0373 00
ASSEMBLY - CONTINUED
140. Install friction disc (19), clutch plate (18) and friction
17
disc (17) in number one clutch housing (4).
141. Install 10 springs (21) and five pins (20).
21
18
19
20
4
394-1271
NOTE
There are three shaft assemblies of this type in carrier. The following assembly procedure is for one shaft
assembly. The assembly procedure for the remaining two shaft assemblies is identical.
142. Install thrust washer (11). Immerse bearing (13) in clean engine oil.
143. Install gear (12), bearing (13), thrust washer (14) and
9
shaft (15) in carrier (8).
10
8
CAUTION
Pins that hold shafts to carriers must be
installed flush with outer surface of carrier.
If they are installed further, they will pre-
11
vent oil flow for lubrication of the gears.
12
144. Use pin punch and hammer to install new spring pin
13
14
(16), if removed.
15
145. Install plate (10) and four bolts (9). Torque bolts to 25
16
lb-ft (34 Nm).
394-1270
0373 00-55
