TM 5-3805-260-10
c.
Removing Load Transfer Equipment. Eight. procedures are necessary to remove load transfer equipment.
(1)
Start the engine, raise the bowl about one foot
and open the bowl floor about six inches. Place a
block under the cutting edge to keep the load
transfer wheels off the ground. Lower the load
transfer axle. Stop the engine.
(2)
Remove the two load transfer wheels from the
bowl cutting edge.
(3)
Disconnect the load transfer axle cylinder eyes
from the lugs on the axle. Start the engine, retract
the cylinders, and stop the engine.
(4)
Disconnect two hoses; one from the dump and
lift valve, and one from the fitting under the
walkplate near the right front fender.
3-12
