TM 5-3805-260-10
(22) Immobilize the ejector by strapping it to the
bracket on the cover of the rear frame using
suitable strapping material.
NOTE
Be prepared to slowly lower lift cylinders until
their weight rests on their lines.
(23) Remove the pins holding the lift cylinders to the
draft frame. Slowly lower cylinders until their weight
rests on their lines. Reinstall pins in the draft frame.
Move lift lever back and forth to relieve pressure on
pins.
(24) Start the engine and carefully retract the
cylinders. STOP THE ENGINE. Operate lift lever in
both directions to relieve pressure in hydraulic lines.
CAUTION
Clean all hose dust caps and plugs and all
quick
disconnects
immediately
before
disconnecting hoses, and install dust caps and
plugs immediately after.
(25) Two people are needed to disconnect the hose
lines from the lift cylinders. Allow cylinders to rest
on the
ground
.
3-19
