TM 5-3805-260-10
(2)
Remove the two load transfer wheels from
the bowl cutting edge. Raise bowl and
remove block. Lower bowl.
(3)
Remove the load transfer axle jacks and
store them in tool box.
NOTE
Proceed to step 5 for normal earth moving
operations. If the Tractor-Scraper must be
roaded with load transfer axle in place, refer to
step 4.
(4)
Raise the load transfer axle to its highest
point. Swing the hold device under the
axle
to
prevent
self-lowering
during
operation. The tractor-scraper is now
ready for operation.
WARNING
Do not proceed with steps 5 through 9 if step 4
was performed.
(5)
Disconnect the load transfer axle cylinder
eyes from the lugs on the axle. Start the
engine, retract the cylinders, and stop the
engine.
1-60