TM 5-2350-262-20-3
3
4
2
1
EJECTOR CIRCUIT PRESSURE CHECK
WARNING
Do not operate ejector when personnel are in bowl. Do not work
in bowl unless ejector lock is engaged. Failure to comply may
result in severe injury to personnel.
NOTE
Have suitable container ready to catch oil.
Remove all test equipment and connect lines.
Disconnect hose (1) from ejector control valve port 22 elbow (2) on the ejector control
valve (3). Plug hose (1).
Install pressure measuring device (4) on elbow (2) in port 22.
Start engine and actuate EJECTOR CONTROL lever (5) to BACK position. Read pressure
measuring device (4). Pressure should be 3,950-4,050 psi (27,235-27,925kPa).
Stop engine; relieve hydraulic pressure. Remove all test equipment and connect hoses.
Refer to TM 5-2350-262-20-2.
3-77
