TM 5-2350-377-13&P
0046
INSPECTION INSTRUCTIONS - Continued
6.
Inspect bearings in accordance with TM 9-214.
END OF TASK
REPAIR INSTRUCTIONS
1.
Any repair procedure peculiar to a specific part or component is covered in the section or paragraph relating
to that item. After repair, clean all parts thoroughly to prevent dirt, metal chips, or other foreign material from
entering any working parts.
2.
Repair casting, forgings, and machined metal parts according to the following instructions:
a.
Refer to TM 9-237 for instructions on repairing minor cracked castings or forgings.
b.
Repair minor damage to machined surfaces with a fine mill file or abrasive cloth dipped in cleaning
compound solvent.
c.
Replace any deeply nicked machined surface that could affect the assembly operation.
d.
Repair minor damage to threaded capscrew holes with thread tap of same size, to prevent cutting
oversize.
3.
Refer to General Hydraulic System Repair Methods (WP 0051) for maintenance on metal lines, flexible lines
(hoses), and metal fittings.
END OF TASK
TAGGING WIRES AND HOSES
1.
As soon as first wire or hose is disconnected, write the number "1" on two tags. Secure one tag to wire or hose
and other tag to terminal, nipple, or fitting. After disconnecting second wire or hose, write the number "2" on
two tags. Secure one tag to wire or hose and second tag to terminal, nipple, or fitting. Do the same for all wires
and hoses.
2.
Note which numbers you used, in pencil, on art in this manual. This will help you to retag properly when you
remove tags from some parts to perform cleaning and maintenance work.
3.
Remove all tags when finished.
END OF TASK
END OF WORK PACKAGE
0046-4
03/15/2011Rel(1.8)root(maintwp)wpno(M00028)
