TM 5-3800-205-10-1
RAIL TRANSPORT - CONTINUED
0021 00
CONFIGURE MACHINE FOR RAIL TRANSPORT - CONTINUED
SIDE MIRROR
UPPER
HANDRAIL
LOOSEN
BOLTS TO
FOLD
MIRROR
390-1020
LOWER
BOLTS, WASHERS, AND
HANDRAIL
NUTS
LOAD MACHINE ONTO FLATCAR
WARNING
Always use a ground guide when driving machine onto flatcars. Failure to use a ground guide may
result in an accident, causing death or injury to personnel or damage to equipment.
If operating machine without ROPS/FOPS, drive with extreme caution, at low idle, and in 1st gear
ONLY. Machine has no rollover/falling object protection without ROPS/FOPS. Failure to follow this
warning may cause injury or death to personnel or damage to equipment.
1.
Remove wheel blocks. Following instructions from railcar load master and ground guides, slowly drive machine straight
onto flatcars.
Use 1st gear ONLY.
a.
b.
When passing over spanners between flatcars, maintain a constant speed. Do NOT jam on brakes or reverse direc-
tion.
c.
Stop machine when directed to do so by ground guide.
2.
Lower bowl and position cutting edge onto suitable shoring.
3.
Ensure steering wheel is centered. Place transmission in N (Neutral) and lock, apply parking brake, and shut down
engine.
