TM 5-3800-205-23-1
FUEL GOVERNOR HOSES AND LINES REPLACEMENT - CONTINUED
0020 00
FUEL HOSE INSTALLATION
CAUTION
Use line wrenches to disconnect/connect fuel lines, to avoid damage to fittings.
NOTE
Perform following steps to install each of four fuel hoses.
Coat new O-rings with fuel prior to installation.
1.
Install new O-rings.
2.
Install fitting (5) and hose (2) on secondary fuel filter (4).
3.
Install fitting (3) and other end of hose (2) on governor (1).
4.
Install hose clamp, screws, and new tiedown straps, as needed, to secure hose (2).
WARNING
If machine is parked indoors, DO NOT run engine unless exhaust fumes are vented to the outside. Failure to
follow this warning may cause injury or death due to carbon monoxide poisoning.
5.
Start engine (TM 5-3800-205-10-1 or TM 5-3800-205-10-2) and check for fuel leaks.
6.
Close engine access door (TM 5-3800-205-10-1 or TM 5-3800-205-10-2).
FUEL TUBE REMOVAL
NOTE
Perform following steps to remove fuel ratio control tube or two fuel tubes.
Fittings include elbows, adapters and O-rings. Discard O-rings when removed.
1.
Remove fuel tube (7) and fitting (6) from governor
6 (HIDDEN) 1
(1).
9
FUEL RATIO
7
8
CONTROL TUBE
0020 00-3
