TM 5-3800-205-23-1
FUEL GOVERNOR HOSES AND LINES REPLACEMENT - CONTINUED
0020 00
FUEL TUBE REMOVAL - CONTINUED
2.
Remove screw and hose clamp, as necessary, to sepa-
6 (HIDDEN) 1
rate each fuel tube.
3.
Remove other end of fuel tube (7) and fitting (9) from
engine inlet manifold (8).
4.
Remove fuel tube (7).
9
FUEL RATIO
7
8
CONTROL TUBE
FUEL TUBE INSTALLATION
CAUTION
Use line wrenches to disconnect/connect fuel lines, to avoid damage to fittings.
NOTE
Perform following steps to install fuel ratio control tube or two fuel tubes.
Coat new O-rings with fuel prior to installation.
1.
Install new O-rings.
2.
Position fuel tube (7) on engine.
3.
Install fitting (9) and fuel tube (7) on inlet manifold (8).
4.
Install hose clamp and screw, as necessary, to secure each fuel tube.
5.
Install fitting (6) and other end of fuel tube (7) on governor (1).
WARNING
If machine is parked indoors, DO NOT run engine unless exhaust fumes are vented to the outside. Failure to
follow this warning may cause injury or death due to carbon monoxide poisoning.
NOTE
It may be necessary to prime fuel system.
0020 00-4
