TM 5-3800-205-23-1
MAIN, FUEL PUMP, START, AND AIR INTAKE HEATER RELAYS REPLACEMENT - CONTINUED
0045 00
START RELAY INSTALLATION
1.
Install wires (25) on terminals (26) with four nuts (24).
2.
Secure relay bracket (21) with two screws (19) and washers (20).
3.
Connect black leads (22) to green and black leads (23).
4.
Slide grommet (3) and cable (4) on panel (2).
5.
Secure panel (2) with nine screws (1).
AIR INLET HEATER RELAY REMOVAL
1.
Open engine access door (TM 5-3800-205-10-1 or TM 5-3800-205-10-2).
2.
Remove two screws (27), washers (28), and relay (29) from firewall.
NOTE
Tag wires to aid in installation.
3.
Remove two nuts (30) washers (31) and leads (32) from terminals (33).
4.
Remove from clip and disconnect relay leads (34) from harness connector leads (35).
29
AIR INLET
27,28
HEATER RELAY
30,31,32,33
34
35
AIR INLET HEATER RELAY INSTALLATION
1.
Connect relay leads (34) to harness connector leads (35). Secure leads in clip.
2.
Install leads (32) on terminals (33) with two washers (31) and nuts (30).
3.
Position relay (29) on firewall and secure with two screws (27) and washers (28).
4.
Close engine access door (TM 5-3800-205-10-1 or TM 5-3800-205-10-2).
END OF WORK PACKAGE
0045 00-5
