TM 5-3800-205-23-1
ROPS/FOPS REPLACEMENT - CONTINUED
0098 00
REMOVAL
1.
Attach slings to three lift points of ROPS/FOPS (1) and attach slings to overhead lifting device. Take up slack in slings.
2.
Remove 16 nuts (2), 32 washers (3), and 16 bolts (4) from four corner posts of ROPS/FOPS (1).
3.
Remove ROPS/FOPS (1) and place on ground. Remove slings.
1
2,3,4
LIFT POINTS
390-1021
INSTALLATION
1.
Attach slings to three lift points of ROPS/FOPS (1) and attach slings to overhead lifting device. Take up slack in slings.
NOTE
Tighten all mounting nuts using a crisscross tightening pattern. This will ensure even tightening and correct
installation alignment on all four cab corner posts.
2.
Lift ROPS/FOPS (1) into position at four corner posts of cab. While positioning ROPS/FOPS, loosely install 16 bolts
(4), 32 washers (3), and 16 nuts (2).
3.
Final tighten nuts (2) in a crisscross tightening pattern to 317 lb-ft (430 Nm).
4.
Remove slings.
END OF WORK PACKAGE
0098 00-2