TM 5-3800-205-23-1
INJECTOR SYNCHRONIZATION, FUEL SETTING, AND FUEL TIMING - CONTINUED
0140 00
FUEL SETTING - CONTINUED
NOTE
If holding tool is installed too tight, governor can be deflected away from engine, making fuel setting adjust-
ments inaccurate.
15.
If small diameter of fuel setting pin (26) does not contact governor calibration face, perform the following:
a.
Disconnect air line (29) from governor fuel ratio control (30).
b.
Connect a regulated air supply to fuel ratio control (30).
c.
Apply 15 psi (195 kPa) to fuel ratio control (30).
d.
After fuel setting check is completed, remove air supply and connect air line (29).
29
30
0140 00-15
