TM 5-3800-205-23-1
INJECTOR SYNCHRONIZATION, FUEL SETTING, AND FUEL TIMING - CONTINUED
0140 00
FUEL SETTING - CONTINUED
NOTE
Slight marring of control rod by locking pliers is acceptable.
Do not clamp locking pliers right next to control rod bearing supports.
Ensure ends of locking pliers do not contact cylinder head bolt under control rod. Locking pliers and
control rod must actuate freely and smoothly throughout rack travel range.
2.
Attach locking pliers (6) firmly to control rod (7). Pliers should be attached at an approximate 45 degree angle.
NOTE
Rotating control rod in "A" direction is FUEL OFF, while rotating control rod in "B" direction is FUEL ON.
3.
Rotate control rod (7) until all injector levers are in shut-off position.
4.
Using locking pliers (6), rotate control rod (7) in "B" direction (rack head will pull away from injector).
6
7
0140 00-10
