TM 5-3800-205-23-1
INJECTOR SYNCHRONIZATION, FUEL SETTING, AND FUEL TIMING - CONTINUED
0140 00
INJECTOR SYNCHRONIZATION - CONTINUED
NOTE
Rotating control rod in "A" direction is FUEL OFF, while rotating control rod in "B" direction is FUEL ON.
6.
Using locking pliers (6), rotate control rod (7) in "B" direction (rack head will pull away from injector).
6
7
7.
Position gage block (11) with 0.138 in. (3.50 mm) wide finger between injector rack head stop pin (9) and square shoul-
der on injector body (8).
8.
Release locking pliers (6) to allow control rod (7) to rotate to "A" direction allowing gage block (11) to be held tightly
and squarely against injector body (8).
9.
Remove bolt (12) nearest injector to be checked.
12
0140 00-5
