TM 5-3800-205-23-1
INJECTOR SYNCHRONIZATION, FUEL SETTING, AND FUEL TIMING - CONTINUED
0140 00
INJECTOR SYNCHRONIZATION - CONTINUED
2.
Install injector synchronization fixture group (4) at no. 1 injector (1) by threading two pins (5) of fixture group into
vacated rocker arm bolt holes. Tighten pins finger tight.
5
4
NOTE
Slight marring of control rod by locking pliers is acceptable.
Do not clamp locking pliers right next to control rod bearing supports.
Ensure ends of locking pliers do not contact cylinder head bolt under control rod. Locking pliers and
control rod must actuate freely and smoothly throughout rack travel range.
3.
Attach locking pliers (6) firmly to control rod (7). Pliers should be attached at an approximate 45 degree angle.
6
7
0140 00-3
