TM 5-3800-205-23-1
FUEL UNIT INJECTOR REPLACEMENT - CONTINUED
0139 00
INSTALLATION
NOTE
Lubricate new preformed packing with clean oil prior to installation.
1.
Install new preformed packing (5) to injector (4).
2.
Install injector (4).
3.
Install socket head capscrew (1) and washer to clamp (2). Tighten to 9 lb-ft (12 Nm).
WARNING
Injector forcing cover has two sharp edges due to design of this tool. Be careful not to cut yourself on these
sharp edges.
4.
Install injector forcing cover (9) with milled surface of cover lined up with injector clamp socket head capscrew (1).
10
9
9
1
1
CAUTION
Complete lubrication of wear button must be maintained for each injector seating procedure. Failure to relu-
bricate each wear button before seating next injector may cause premature wear or tool damage.
5.
Apply a small amount of petrolatum to top of injector forcing cover wear button (10).
0139 00-3
