TM 5-3800-205-23-1
INJECTOR SYNCHRONIZATION, FUEL SETTING, AND FUEL TIMING - CONTINUED
0140 00
FUEL SETTING - CONTINUED
NOTE
Refer to engine information plate, located at upper-right hand corner of valve cover, for correct fuel setting.
ENGINE INFORMATION PLATE
18.
If indication on indicator is within 0.25 mm of specified fuel setting, go to step 23. If indication on indicator is not
within 0.25 mm of specified fuel setting, go to step 19.
19.
Using adjustment wrench, loosen locknut (19) on fuel setting screw (20).
20.
Adjust fuel setting screw (20) until indication matches correct fuel setting. Turn screw counterclockwise for more fuel
(greater fuel setting) or clockwise for less fuel (lower fuel setting).
CAUTION
DO NOT loosen screws holding clamps on control rod. Loosening clamps will cause poor engine perfor-
mance and may damage engine. Clamps are factory preset onto rod.
21.
Hold fuel setting pin (26) in place and tighten locknut (19).
22.
Recheck fuel setting by "flipping" rack lever (32). Check indication again. If fuel setting is not correct, repeat steps 19
through 21 above until correct setting is obtained.
23.
Remove holding tool (31) and fuel setting pin (26) from governor (23).
26
28
31
0140 00-17
