TM 5-3800-205-23-1
TRANSMISSION/TRANSFER ASSEMBLY REPLACEMENT - CONTINUED
0147 00
INSTALLATION
1.
Install each mounting bracket (29) to transmission/transfer assembly with four washers and bolts. Tighten bolts to 272
lb-ft (370 Nm).
2.
Position mount assembly (30) and spacer on each side of frame (34).
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during proce-
dure. Ensure that any lifting device used is in good condition and of suitable lift capacity. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may result in death or injury to
personnel.
NOTE
Transmission/transfer assembly weighs 1488 lb (675 kg).
3.
Use link bracket, lifting eyebolt, and a suitable three-
26,27
28
point lifting chain and hoist to position transmission/
transfer assembly on machine.
4.
Place mount assembly (33) on each mounting bracket
(29). Install large washer (28), washer (27), bolt (26),
washer (32), and nut (31) on each rear mount.
34
29
30
31,32
33
0147 00-7