TM 5-3800-205-23-1
DRAFT FRAME, HITCH, AND TRACTOR FRAME PINS AND
BEARINGS REPLACEMENT - CONTINUED
0155 00
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during
procedure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep
clear of heavy parts supported only by lifting device. Failure to follow this warning may result in injury
or death to personnel.
DO NOT perform fuel system checks, inspections or maintenance while smoking or near fire,
flames or sparks. Clean up all leaked or spilled fluids. Fuel may ignite, causing damage to machine
and injury or death to personnel.
Do NOT disconnect any air system lines or fittings unless vehicle engine is shut down and air system
pressure is relieved. Failure to follow this warning could result in serious injury to personnel.
Always wear eye protection when disconnecting air lines. Residual air will be expelled. Failure to fol-
low this warning may result in serious eye injury.
NOTE
Tag all lines, hoses, wires, and tubes to aid in installation.
Cap all lines, hoses and tubes to prevent fluid loss and contamination of oil system.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance,
testing, adjusting and repair of the machine. Be prepared to collect fluid with suitable containers before
opening any compartment or disassembling any component containing fluids.
Dispose of all fluids according to local regulations and mandates.
Remove tiedown straps as needed and discard. Use new tiedown straps on installation.
0155 00-2
