TM 5-3800-205-23-1
HYDRAULIC AND STEERING PUMP REPLACEMENT
THIS WORK PACKAGE COVERS
Removal, Installation
INITIAL SETUP
Maintenance Level
Materials/Parts - Continued
Tag, marker (Item 39, WP 0171 00)
Direct Support
O-ring (6)
Tools and Special Tools
Personnel Required
Tool kit, general mechanic's (Item 33, WP 0172
Two
Referemces
Materials/Parts
Cap set, protective (Item 5, WP 0171 00)
Oil, lubricating (Item 24 or 29, WP 0171 00)
Equipment Condition
Rag, wiping (Item 31, WP 0171 00)
Hydraulic tank drained (WP 0010 00)
Strap, tiedown (Item 38, WP 0171 00)
Rear guard plate removed (WP 0100 00)
WARNING
Do NOT disconnect or remove any hydraulic system line or fitting unless engine is shut down and
hydraulic system pressure has been relieved. Tighten all connections before applying pressure. Escap-
ing hydraulic fluid under pressure can penetrate the skin, causing serious injury.
At operating temperature hydraulic oil is hot. Allow hydraulic oil to cool before disconnecting any
hydraulic lines. Failure to do so could result in injury.
CAUTION
Cap all hoses and tubes to prevent fluid loss and contamination of oil system.
NOTE
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance,
testing, adjusting and repair of the machine. Be prepared to collect the fluid with suitable containers
before opening any compartment or disassembling any component containing fluids.
Dispose of all fluids according to local regulations and mandates.
Tag all hoses and tubes to aid in installation.
